Follow these next steps to boot MotionEyeOS on your RPi 2 or 3:
#Raspberry pi ip camera viewer download#
Choose and download the right image for your device: MotionEyeOS releases page.You can use the SD Card Formatter software.
#Raspberry pi ip camera viewer install#
Burning MotionEye image to the microSD cardįollow the next steps to install MotionEyeOS on the microSD card for your Pi. You need to install MotionEyeOS on your Raspberry Pi, preferably a Raspberry Pi 2 or Raspberry Pi 3. In this setup, the power leads yellow/black are soldered directly to the back of the Raspberry Pi Zero board. The Raspberry Pi boards are being powered with a 12V DC 1500mA wallwart connected to 5A DC-DC converter set to around 5.2V output (this is a temporary setup for testing, after testing that everything is working fine, each Raspberry Pi Zero W should have a separated power supply). Each Raspberry Pi Zero W board is connected to a camera. The setup for the cameras consists of 4 Raspberry Pi Zero W with a Sandisk Ultra 16GB class 10. A friend of mine has suggested putting a beefy cap in parallel with the RPi power input Cameras Setup Note: I have found that my SATA drive is capable of being powered by the RPi 2 USB without a powered USB hub. Note: I have been doing some experimentation with powering RPi 2 and 3 and found that using a 12V 1500mA wallwart adapter and a 3 or 5A DC-DC converter with short leads seems more capable and often cheaper than a big 3A wallwart adapter, and gives you a 12V supply for other associated hardware. The Raspberry Pi is being powered with a 12VDC 1500mA wallwart connected to 2A DC-DC converter set to around 5.2V output. There is a 1TB SATA drive connected to the Pi with a SATA-USB cable. The Raspberry Pi Hub setup consists of a Raspberry Pi 2 Model B (if you have a RPi 3, use that board instead) with a Sandisk Ultra 16GB class 10. You can use the preceding links or go directly to /tools to find all the parts for your projects at the best price! 4x Standard micro usb 5V 2.5A power supply.
4x MicroSD Card 8 or 16GB – the fastest you can afford.4x Raspberry Pi Camera (read What’s the Best Raspberry Pi Camera For Your Project?).4x Raspberry Pi Zero W (with built-in Wi-Fi).1x 5V power supply capable of powering both the Raspberry Pi and the SATA drive separately.1x MicroSD Card 8 or 16GB – the fastest you can afford.1x Raspberry Pi 3 (or any other model you have).Here are all the parts needed for this project. The following figure shows a high-level overview of the project. The surveillance system built includes: one Raspberry Pi acting as a HUB with 1TB SATA, and 4 cameras (each one connected to a Raspberry Pi Zero W) that can be monitored through the HUB.Īll devices are connected to your local network, and you can access all the cameras through the hub using a browser on your computer (or other device on the local network). This project was written by Julian Silver and edited by Rui Santos and Sara Santos.įor an introduction to the MotionEyeOS, you can read this introductory blog post.
0 kommentar(er)
